MODEL “138CLRSS”

Driving Belt – “B” section V-belt.
Bed – Roller bed width between frames, 10″ 13″, 16″, and 22″.  5-1/2″ x 1-1/2″ x 12 gauge powder painted formed steel channel frame.
Tread Rollers – 1-3/8″ diameter x 18 gauge galvanized steel tread rollers, 1-1/2″ centers, 5/16″ hex shaft for 13″ to 19″ OAW.  2-1/2″ to 1-11/16″ tapered roller for 25″ OAW conveyor, 7/16″ hex shaft.
Pressure Sheaves – 3″ diameter x 3/8″ bore, adjustable to give required driving force.
Floor Supports – One support adjustable 30″ to 44″ from floor to top of rollers. Center leg on outer rail of “138CLRS”.
Tangent – 12″ long, on one end of curved spur.
Take-Up – Screw take-up provided to insure proper V-belt tension.  Mounted in conveyor frame.
End Drive – Mounted below bed section.
Bearings – Sealed pre-lubricated with cast iron housings.
Speed Reducer – C-Face mounted heavy duty worm gear reducer.
Motor – 1/2 HP 230/460-3-60 TE motor.
Conveying Speed – 60 FPM constant.
Capacity – 300 lbs. total distributed live load.
(For Optional Equipment, Weight Specifications, and Engineering Line Drawings, please see catalog pages, above).

ACSI Paint Colors

(Optional colors available at extra cost)

Guard Rails – Adjustable channel, continuous channel,steel guard rails available.

FloorSupports – Lower or higher supports are available. Minimum elevation 151 ⁄2″.

Ceiling Hangers – 1 ⁄2″ diameter threaded rods 8 feet long with locking nuts and mounting hardware. Other lengths are available.

Side Mounted Drive – End drive mounted to side of conveyor bed section. Minimum elevation 8″. Specify side.

Motor – Single phase, energy efficient, explosion proof, etc. Other HP available. Conveying Speed – Variable and other constant speeds available.

Electrical Controls – Magnetic starters and push button stations; manual motor starters with overload protection, others