MODEL “251ACDA”

Frame – Heavy duty 7″ deep x 4 gauge powder painted formed steel channel with heavy duty cross braces.  Frames are bolted together with splice plates and floor supports.
Rollers– 2-1/4″ diameter x 11 gauge steel rollers, grease packed and labyrinth sealed bearings, 11/16″ hex shaft.  Rollers are spaced on 4″ or 6″centers, set 2-1/4″ low.
Floor Supports – Adjustable 18-3/4″ to 23-3/8″ (HD-4) from floor to top of roller, for each end of conveyor and at each bed joint along with knee braces for each support.  Supports on 5 foot centers, changes with zone length.
Drive – Located near center of conveyor length, shaft mount motor and reducer.
Drive Chain – RC #40 chain used for roller to roller connections, RC #60 chain drives each zone.  Chains are totally enclosed by metal guards.
Accumulation Zones– Standard zone lengths are 60″ long with a maximum of 30 zones per single drive.  Eachzone is driven by an air clutch and controlled by a sensor roller.
Motor– 3/4 HP 230/460-3-60 TE motor.
Electrical Controls – 110/1/60 electric solenoid and air switch for discharge zone.
Conveyor Speed– 30 FPM constant roller speed.
Capacity – 4000 pounds maximum unit load.  Total conveyor live load not to exceed Load Capacity Chart (see catalog page).
Speed Reducer – Heavy duty, sealed worm gear, C-Face.
Bearings – Sealed pre-lubricated with cast iron housings.
(For Optional Equipment, Weight Specifications, and Engineering Line Drawings, please see catalog pages, above)

ACSI Paint Colors

(Optional colors available at extra cost)

Accumulation Zones – 4″ roller centers – 36″, 40″, 44″, 48″, 52″, 56″ and 72″ long. 6″ roller centers 36″, 42″, 48″, 54″ and 72″ long. Frame lengths change with zone lengths.

Tread Rollers – 25 ⁄8″ diameter x 7 gauge steel, 11⁄16″ hex shaft.

Floor Supports – Higher or lower supports available, adjustable or fixed type.

Conveyor Speed – Constant and variable speeds (Contact Factory).

Limit Switch – to provide signal for customers infeed equipment.

Time Delay – Allows for product to be unloaded from discharge zone of conveyor without movement of next load into discharge zone.

Sensing Devices – Photo cells, limit switches, etc. can be supplied for electrically operated zones in lieu of mechanical sensing devices.

Motor – Single phase, energy efficient, explosion proof, etc. Other HP available.

Electrical Controls – Magnetic starters and push button stations; Manual motor starters with overload protection, others. 24V DC solenoid can be supplied in lieu of 110V AC solenoid in discharge zone.

Optional Loads – Larger capacity clutch is available for 6000 lb. unit loads. Reversible – can be supplied with reversing feature to allow accumulation in both directions.