MODEL “190CLRS”

Driving Belt – “B” section V-belt.
Bed – Roller bed width between rails 15″, 21″, 27″, 33″ and 39″. 7-1/2″ x 1-1/2″ x 12 gauge powder painted formed steel channel frame.
Tread Rollers – 2-1/2″ diameter tapered to 1-11/16″ diameter plated and 1.9″ diameter x 16 gauge plated steel tread rollers, 7/16″ hex shaft.
Pressure Sheaves – 3″ diameter x 3/8″ bore, adjustable to give required driving force.
Take-Up – Screw take-up provided to ensure proper V-belt tension.  Mounted underneath conveyor.
Tangent – 12″ long, on one end of curved spur.
Floor Supports – Adjustable 31-1/2″ to 45-1/2″ from floor to top of rollers.
End Drive – Mounted below bed section.
Bearings– Sealed pre lubricated with cast iron housings.
Speed Reducer – C-Face mounted heavy duty worm gear reducer.
Motor– 1/2 HP 230/460-3-60 TE motor.
Belt Speed – 60 FPM constant.
Capacity – 540 Ibs. total distributed live load.
(For Optional Equipment, Weight Specifications, and Engineering Line Drawings, please see catalog pages, above).

ACSI Paint Colors

(Optional colors available at extra cost)

Guard Rails – Adjustable channel, continuous channel,steel guard rails available.

Floor Supports – Lower or higher supports are available. Minimum elevation, 17″ from floor to top of rollers.

Ceiling Hangers – 1⁄2″ diameter threaded rods 8 feet long with locking nuts and mounting hardware. Other lengths are available.

Center Drive – Mounted underneath bed section in center of spur.

Side Mounted Drive – End drive mounted to side of conveyor section. Specify side. Minimum elevation – 9-1⁄2″ from floor to top of rollers.

Motor – Single phase, energy efficient, explosion proof, etc. Other HP available.

Belt Speed – Constant and variable belt speeds available.

Electrical Controls – Magnetic starters and push button stations; manual motor starters with overload protection, others.