Model “190CAP”

Driving Belt — 8″ wide for 15″ and 21″ between frames, 12″ wide for 27″ between frames, and 16″ wide for 33″ and 39″ between frames; black PVC 120 belt.

Bed — Roller bed width between frames: 15″, 21″, 27″, 33″, and 39″. 7″ x 1-¹/₂″ x 12 gauge powder painted formed steel channel frame, bolted together with butt couplings and floor supports.

Tread Rollers — 1.9″ diameter x 16 gauge galvanized steel rollers spaced on 2-¹/₄″, 3″, 4-¹/₂″, or 6″ centers. Safety pop-out design helps prevent damage to product or harm to personnel if caught between belt and tread rollers.

Pressure Rollers — 1.9″ diameter x 16 gauge galvanized steel rollers spaced on 6″, 9″, or 12″ centers, cam adjusted.

X-Bracing — Frame squaring device supplied on conveyors 40 feet and longer on every other bed section. X-bracing helps ensure good product and belt tracking.

Tail Pulley — 4″ diameter crowned with 1-³/₁₆″ shaft.

Drive Pulley — 8″ diameter crowned and fully lagged with 1-⁷/₁₆″ diameter shaft.

Snub Roller — 2-¹/₂″ diameter adjustable, located directly behind drive pulley. 2″ diameter at each end directly behind terminal pulleys.

Return Idlers — 1.9″ diameter adjustable on 10′0″ centers.

Floor Supports — 31-¹/₂″ to 45-¹/₂″ adjustable from floor to top of rollers. One support supplied at each end of conveyor and at each bed joint.

Take-Up — Located in center drive, provides 24″ of belt take-up.

Bearings — Sealed and prelubricated with cast iron housings.

Speed Reducer — C-Face mounted heavy duty worm gear reducer.

Motor — ¹/₂ HP 230/460-3-60 TE motor.

Belt Speed — 60 FPM constant.

Capacity — 150 pounds per foot. Not to exceed Load Capacity Chart.

Guard Rails — Adjustable channel, continuous channel, or solid steel guard rails available.

Floor Supports — Lower or higher supports available. Minimum elevation 20″.

Ceiling Hangers — ¹/₂″ diameter threaded rods 8 feet long with locking nuts and mounting hardware. Other lengths are available.

Side Mounted Drive — End drive mounted to side of conveyor bed section. Specify side. Minimum 9″ elevation with 4″ drive pulley, minimum 12″ elevation with 8″ drive pulley.

Motor — Single phase, energy efficient, explosion proof, etc. Other HP available.

Belt Speed — Constant and variable belt speeds available.

Electrical Controls — Magnetic starters and push button stations; manual motor starters with overload protection, others.