Model “190RBW”

Belt Width — 12", 18", 24" and 36" wide, ½"x1" flat wire belt.

Bed — 1.9" diameter rollers mounted on 6" centers in 6½" deep x 12 gauge powder painted formed channel, bolted together with splice plates and supports.

Drive Sprockets — 6" pitch diameter cast iron sprockets machined for 13⁄16" diameter shaft.

Tail Pulley — 4" diameter with 4" pitch diameter cast iron sprockets on each end of pulley, 13⁄16" diameter shaft.

Snub Roller — Adjustable 2" diameter roller located directly behind drive sprockets and tail sprockets.

Return Idlers — 1.9" diameter, adjustable, on 10'0" centers.

Bearings — Sealed and prelubricated with heavy duty housing.

Floor Supports — Adjustable 31" to 45" from floor to top of belt. One support supplied at each end of conveyor and at each bed joint.

Speed Reducer — C-Face mounted heavy duty worm gear reducer.

Motor — ½ HP 230/460-3-60 TE motor.

Belt Speed — 60 FPM constant.

Capacity — Maximum load per linear foot of conveyor - 75 pounds. Not to exceed Load Capacity Chart.

Belt — ½" x ½" flat wire, galvanized, stainless steel. Others available.

Guard Rails — Adjustable channel, continuous channel, or solid steel guard rails available.

Floor Supports — Lower or higher supports available.

Ceiling Hangers — ½" diameter threaded rods 8 feet long with locking nuts and mounting hardware. Other lengths are available.

Side Mounted Drive — End drive mounted to side of conveyor. Specify side. Minimum elevation 10".

Overhead Drive — End drive mounted above conveyor. Specify clearance required.

Motor — Single phase, energy efficient, explosion proof, etc. Other HP available.

Belt Speed — Constant and variable belt speeds available.

Electrical Controls — Magnetic starters and push button stations; manual motor starters with overload protection, others.